ClickTronic 60810 Manual Del Usuario página 19

• Use the RESET button on the remote control
to set the product into initial condition.
This action is a circular function.
When you have choosed a channel, the dedi -
cated LED flashes on. E.g. Choose channel 1 –
LED CH1 flashes on.
3D Application:
1. Ensure all devices (HDTVs, Receivers, cables,
Blu-Ray Players, etc.) support the same 3D
TM
formats.
2. If a device supports no 3D, on all devices 2D
will be displayed.
3D Video format:
Frame packing:
1920 x 1080p@23.98/24 Hz
1280 x 720p@59.94/60 Hz
1280 x 720p@50 Hz
Side-by-Side (Half):
1920 x 1080i@59.94/60 Hz
1920 x 1080i@50 Hz
Top-and-Bottom:
1920 x 1080p@23.98/24 Hz
1280 x 720p@59.94/60 Hz
1280 x 720p@50 Hz
5.5 Operation Mode Overview:
Starting
Mode
Output A • The source
& B device automa-
- tically adjusts to
adjusted a audio- and
to use one video format,
source supported by all
device connected
together devices. The
output device
SPLITTER with the highest
MoDE compatibility
to the source
device will be
adjusted as
primal device.
(mode of the
highest common
accordance)
• You can also
adjust the audio-/
video signal
manually. Make
sure, the output
devices support
these adjust-
ments.
Clicktronic®
supported not supported
• The audio-/video
format of the
source device
must be adjusted
first.
• Please make
sure, the output
devices support
these adjust-
ments.
(e.g.You want the
source device
sending a 1080p
video signal,
although the out-
put device only
supports up to
720p or 1080i.
Then no picture
will be shown.)
Resetting:
19