JAROLIFT TDEF10/14 Instrucciones Originales página 100

EINSTELLUNGEN
SETTINGS / PARAMÈTRES / AJUSTES / IMPOSTAZIONI / INSTELLINGEN /
USTAWIENIA / AYARLAR
Setting of the upper end point.
1. Press the UP button on your transmitter.
2. Raise the roller shutter until the desired end point is reached.
ATTENTION! The roller shutter locking bar (end bar) must still be visible
from the outside.
3. Stop the motor at the desired position using the STOP button.
4. Correct the upper end point with the UP/DOWN and STOP buttons if necessary.
5. Press the UP and DOWN buttons on the transmitter at the same time
6. Then press the STOP button 2x.
7. Press the UP button briefly within 10 seconds.
The motor will confirm the setting of the upper end point by vibrating briefly.
UP
Let the roller shutter roll up and down completely several times as a test.
If the roller shutter stops at the set end points, the limit switch setting is complete
and the roller shutter casing can be closed.
To change the end points, please start from the beginning.
Always set both end points at a time!
Please note that the motor is equipped with a thermal protection
switch and it is possible that the motor will switch off automatically for
safety reasons if it reaches a high temperature after a few operations.
After a cooling period of approx. 15-20 minutes, the motor will be ready
for use again.
100
STOP UP and
DOWN
2 x STOP UP