Tabla de contenido
Publicidad
MONTAGE
INSTALLATION / MONTAGE / MONTAJE / MONTAGGIO / MONTAGE / MONTAŻ / MONTAJ
ATTENTION!
Do not drill or screw into the motor!
When installed, the unrolled roller
shutter must run vertically into the
guide rail of the roller shutter.
Make sure that the brackets and/or the
shaft are installed horizontally.
A roller shutter that rolls up crookedly
can block and destroy the motor.
Make sure that the motor is fitted in
such a way that the programming but-
ton (Fig. 5) remains easily accessible!
42
5
Programming button
6
ATTENTION!
Please use steel strip hangers, also
called retaining springs, to fix the roller
shutter to the shaft.
When installing 35 mm motors in
40 mm roller shutter shafts or 45 mm
motors in 50 mm roller shutter shafts,
it is recommended to use so-called sus-
pension clamps (Fig. 6) for the retain-
ing springs.
The clamps ensure that the roller shut-
ter motors are not damaged by the
dovetails of the retaining springs.
If you insert screws into the roller
shutter shaft in order to hang the roller
shutter, please make sure that they are
short enough so they do not touch the
motor under any circumstances!
Publicidad
Tabla de contenido
