Bevel Cut; Compound Cut - Stanley FATMAX FME720 Manual Del Usuario

ENGLISH
Adjust the fence to be as close to the blade as practical to
u
provide maximum work piece support, without interfering
with the up and down movement of the arm.
Tighten the high sliding fence clamp (20) to secure the
u
fence in place.
Warning! The guide groove can become clogged with saw-
dust. Use a stick or low pressure air to clear the guide groove.

Bevel cut

Make sure that the high sliding fence is adjusted to the
u
correct orientation before adjusting the bevel angle.
Note: The saw is fitted with a special 33.9° bevel pin (23) for
special crown moulding.
Loosen the bevel lock handle (30) (fig. F) and move the
u
cutting head to the required angle. Tighten the bevel lock
handle (30).
Operate the on/off switch, then press the release lever
u
(36) when the saw reaches full speed, push the main
operating handle (2) down slowly, cutting through the
workpiece.
When the saw reaches full speed, push the main operat-
u
ing handle (2) down slowly, cutting through the leading
edge of the workpiece.
Slowly move the main operating handle (2) toward the
u
fence to complete the cut.
Release the on/off switch (3) and allow the blade to stop
u
before allowing the cutting head to rise.
Make sure that the arm is securely locked when bevelling.
u

Compound cut

Make sure that the high sliding fence is adjusted to the
u
correct orientation before adjusting the bevel angle to
make a compound cut.
A compound cut is a combination of mitre cut and bevel cut.
Switch the laser on/off switch (1) to on.
u
Refer to the above procedures to perform this cut.
u
When the saw reaches full speed, push the main operat-
u
ing handle (2) down slowly, cutting through the leading
edge of the workpiece.
Slowly move the main operating handle (2) toward the
u
fence to complete the cut.
Release the on/off switch (3) and allow the blade to stop
u
before allowing the cutting head to rise.
12
(Original instructions)
Base moulding cut
Base moulding can be cut vertical against the fence or flat on
the table.
Refer to the following table:
u
Vertical position
(back of moulding is
Settings
against the fence)
Bevel angle 0 º
Moulding position Left side
Inside
Left at
corner
Mitre angle
45 º
Bottom
Moulding
against
position
table
Keep left
Finished
side of
side
cut
Vertical position
Settings (back of moulding is
against the fence)
0 º
Bevel angle
Left at
Outside
Mitre angle
45 º
corner
Bottom
Moulding
against
position
table
Keep left
Finished
side of
side
cut
Horizontal position
(back of moulding is
flat on the table)
45 º
Right Right
Left side
side side
Right at
0 º 0 º
45 º
Bottom Top Bottom
against against against
table fince fence
Keep Keep left Keep left
right side side of side of
of cut cut cut
Horizontal position
(back of moulding is
flat on the table)
45 º
Right at
0 º 0 º
45 º
Bottom Top Bottom
against against against
table fince fence
Keep Keep Keep
right side right side right side
of cut of cut of cut