Initial Configuration; Setting The Time & Date - Conceptronic Home Media Store CH3ENAS Manual De Usuario Ampliado

4.3

Initial configuration

Before you can start using the Home Media Store as a network storage location, some device settings must be
made. These settings are described in the subchapters below.
4.3.1 Setting the time & date
 Select "GENERAL" in the top bar of the configuration page.
 Select "DATE / TIME" in the left bar of the configuration page.
The „DATE / TIME‟ configuration will be shown on your screen:
By default, the Home Media Store will obtain the date & time automatically from the internet by using a time
server, which is listed in the field „NTP server‟.
You can verify if the correct date & time is obtained from the internet in the section „Current date & time‟.
If the date & time settings are correct, you can proceed to chapter 4.3.2 to change the network configuration.
If the date & time are not correct, you can use the settings on this configuration page to modify the date & time
to the correct settings.
 Select if you want to configure the date & time "Manually" or "Automatically".
When you select to configure the date & time "Manually", you need to set the date & time in the „Current date &
time‟ section to the correct values.
 Click "Select" to popup a calendar to select the correct date.
 Use the dropdown menus to select the correct time.
 Click the "Apply" button in the „Current date & time‟ section to save the manual date & time settings.
ENGLISH
53