Voltage; Electrical Connectors - J4C S20 Instrucciones Puesta En Marcha

ENGLISH
- J4C 20 TO 300 INSTALLATION INSTRUCTIONS
READ THESE INSTRUCTIONS BEFORE CONNECTING THE ACTUATOR. DAMAGE CAUSED BY NON
COMPLIANCE OF THESE INSTRUCTIONS IS NOT COVERED BY OUR WARRANTY.
J4C Electric actuators operate with the use of live electricity. It is recommended that only qualified
electrical engineers be allowed to connect or adjust these actuators.

1. VOLTAGE

·
All our actuators model S20 to S300 are ready to work from 24 to 240 VAC / 24 to 135 VDC.
·
All our actuators model B20 to B300 are ready to work at 12 VAC/VDC ONLY.
·
All our actuators model H20 to H300 are ready to work from 85 to 240 VDC/VAC.

2. ELECTRICAL CONNECTORS

Warning:
are DIN plugs. Ensure the diameter of cable to be used conforms to the maximum and minimum
Warning: Ensure that the square rubber seal is in place when fixing each DIN plug to the actuator.
1. Gasket
2. Terminal strip
3. Cable fixing screws
4. Housing
5. Washer
INDEX
6. Grommet
7. Gland - nut
8. Fixing screw
9. Washer
10. Gasket
(Fig.1)
(Fig.2)
0 0 3