Liability Exclusion; Operating Elements; Commissioning, Operation; Setting The Temperature - Renfert Waxprofi Manual Del Usuario

► It is the responsibility of the operator that national regulations during operation and regarding
a repeated safety inspection of electrical equipment are complied with. For Germany these are
the regulation 3 by DGUV (German Statutory Accident Insurance) in relation with VDE 0701-0702
EN (Association for Electrical, Electronic and Information Technology).
► Only spare parts and accessories supplied or authorized by Renfert GmbH may be used with this
product. If other spare parts or accessories are used, this could have a detrimental effect on the
safety of the device, increase the risk of serious injury and lead to damage to the environment or
the device itself.
► Information on REACH and SVHC is available on our website www.renfert.com, in the Support
area.
3.3

Liability Exclusion

Renfert GmbH shall be absolved from all claims for damages or warranty if:
► The product is employed for any purposes other than those cited in the operating instructions.
► The product is altered in any way other than those alterations described in the operating instructions.
► The product is repaired by other than an authorized facility or if any but Renfert OEM parts are
employed.
► The product continues to be employed, despite obvious safety faults.
► The product is subjected to mechanical jarring or is dropped.
4

Operating Elements

(Figure 1a + 1b)
A) On / Off switch
B) Rotary potentiometer for temperature adjustment
C) Wax pot
D) Lid
E) Power cord
F) LED indicator
>> Operating indicator = green;
>> Heating phase = red
5 Commissioning / Operation
1. Connect the Waxprofi to the mains power outlet (Figure 2).
2. Open lid (D). The lid can be locked in place at a 120° angle (Figure 3).
3. It may be necessary to fold wax sheets (Figure 4a).
4. Add the waxes to be heated to the pot (Figure 4b).
Fill up the pot only to the circular marking (Figure 7)!
Folding or breaking the denture wax sheets to fit the pot volume is the most practical method.
When operating the unit for the first time, fill the wax pot in stages.
5. Switch the Waxprofi on at switch (A).
5.1

Setting the Temperature

The desired temperature is adjusted at the rotary potentiometer (B). The scale divisions are identified in
both °C (blue) or °F (red) (Figure 5).
The temperature is infinitely adjustable within the range is between 40 - 110 °C (104 - 230 °F).
We recommend the following procedure when commissioning the Waxprofi in order to obtain the desired
wax consistency:
1. Set the Waxprofi temperature to 15 - 20 °C (59 - 68 °F) above the liquefaction point of the base wax.
2. Depending on the desired consistency, reduce the Waxprofi's temperature as follows:
a) Liquid consistency:
Once the wax has completely melted, turn the Waxprofi's temperature down to the liquefaction point of
the wax.
b) Viscous or spreadable consistency:
Once the wax has liquefied to the point where it fills the pot to approx. the ¾-full level (Figure 6), reduce
the Waxprofi's temperature in stages until the desired consistency is obtained.
- 2 -