Control Panel; Switching On The Roof Air Conditioner - Waeco CoolAir CA-1000-AC Instrucciones De Montaje Y Uso

_CA-1000.book Seite 45 Freitag, 28. Juli 2006 10:35 10
CoolAir
6.2

Control panel

You can regulate the system using the control panel.
The following control and display elements are available for operating the
system:
No. in
Fig. 15
6.3

Switching on the roof air conditioner

➤ With the system switched off, press the ON/OFF button (see
✓ The fan starts at the preset speed.
✓ The Power LED (see fig. 15 on page 7, 8) lights up green.
✓ The digital display (see fig. 15 on page 7, 5) shows the set
The system switches on the compressor after a delay of 30 seconds and
the Compressor LED (see fig. 15 on page 7, 8) lights up orange.
Explanation
1 ON/OFF button
2 Fault LED (red):
The LED indicates system malfunctions.
3 Compressor LED (yellow):
The LED lights up when the compressor is operating.
4 Mode button:
You can use the Mode button to switch between operating modes 1, 2
and Automatic.
5 Digital display:
This displays:
The selected operating mode
for automatic mode
A
selected room temperature in °C
6 + button:
The + increases the temperature by 1 °C.
7 - button:
The - decreases the temperature by 1 °C.
8 Power LED (green):
The LED indicates that the system is switched on.
fig. 15 on page 7, 1).
temperature in °C and the operating mode (e.g.
mode + set temperature 20 °C).
for operating mode 1
for operating mode 2
Operation
for automatic
A20
45