Low Battery Indicator - ProMed T-6 Manual Del Usuario

o
peratIng the unIt
Check the recording memory
1.
The Promed T-6 device can record 30 times treatment data. In
the waiting or setting state, to check the memory data, press the
"SET" button (F) and hold on for 5 seconds, the device will enter
the memory state. First, the last therapeutic program recoding
will display on the LCD, you can press the "SET" button (F) again
to check the treatment parameter of this program (treatment time,
pulse rate and pulse width).
2.
Press " " (G) or " " (H) button to check other therapeutic
program memory.
3.
If you want to back the waiting or setting state, press the
"MODE" button (E) or wait for 30 seconds without any
operation in the panel.
4.
To clear the memory, press the "SET" button (F) and hold on for
5 seconds, the symbol of "D" will be flash on the LCD to remind
the user to delete the memory. You can press the "SET" button (F)
again to delete the memory.

Low battery indicator:

When the low power indicator (8) flashes, the batteries should be
replaced with new ones as soon as possible. However, the device
will continue to operate for several more hours. When the device
power off, the current state will be saved automatically.
Turn the device off
Push "Power ON/OFF" switch (A) down to turn off the device.
Caution
If there is no operation in the panel in waiting state, you will hear
a "DI" sound after one minute and hear two "DI" sounds after two
minutes; and then the device will automatically turn into the power
saving state after three minutes, LCD will close the display and you
will hear three times "DI" sounds. You can press any button in the
panel to activate the display.
30
DE
EN
FR
IT
ES
NL
RU
PL
SE
FI