Garmin aera 660 Guía De Referencia Rápida página 20

Secure the cable on the top of the yoke mount:
1) Remove the screws securing the cable clamp.
2) Orient the cable and secure the clamp with the screws.
Cable Clamp
Remove the yoke mount from the yoke shaft (or control arm):
1) Disconnect the cable connectors from the aircraft.
2) Loosen the clamp by turning the Clamp Adjustment Knob until the clamp
assembly can be easily removed from the yoke shaft or control arm.
www.garmin.com
4
™ Y M I
OKE OUNT NSTALLATION
The aera yoke mount comes fully assembled as shown below. The yoke mount is
Clamp Adjustment Knob
WARNING: It is the sole responsibility of the owner/operator of the aera to place
this mount and secure the unit so that it will not interfere with the aircraft's operating
accident or turbulence. Do not mount the aera where the pilot or passengers are
consequences.
Attach the yoke mount to yoke shaft or control arm:
1) Open the clamp by turning the Clamp Adjustment Knob until it can be easily
placed over the yoke shaft or control arm. Install the yoke mount as far from the
panel as is practical.
2) When in place, tighten the Clamp Adjustment Knob to secure the yoke mount to
the yoke shaft or control arm.
NOTE:
of the applicable aircraft and that the aera yoke mount and wiring do not cause any
I
NSTRUCTIONS
and center column controls.
aera Cradle
1