Storage; Assistance And Repairs; Warranty Coverage; Maintenance Table - Stiga ST 4851 AE Uso Y Mantenimiento

Ocultar thumbs Ver también para ST 4851 AE:
Tabla de contenido

Publicidad

Never wash the snow thrower with
water, otherwise the electric device will be
damaged causing the risk of electrocution.

9. STORAGE

If you intend to put your machine 
away for more than 30 days:
5. Clean the snow thrower thoroughly.
6. Check for any damage. If necessary, 
see to the necessary repairs.
7. If the paintwork is damaged, 
touch it up to prevent rust.
8. Protect any exposed metal surfaces from rust.

10. ASSISTANCE AND REPAIRS

This manual provides all the necessary 
information to run the machine and for correct 
basic maintenance operations which can 
be performed by the user. Any regulations 
and maintenance operations not described 
herein must be carried out by your Dealer 
or Authorized Service Centre, which have 
the necessary knowledge and equipment to 
ensure that the work is carried out correctly, 
maintaining the correct degree of safety and the 
original operating conditions of the machine.
Any operations performed in unauthorized 
centres or by unqualified persons will totally 
invalidate the Warranty and all obligations 
and responsibilities of the Manufacturer.
• Only authorized service workshops can carry 
out guaranteed repairs and maintenance. 
• The authorized service workshops 
only use genuine spare parts. Genuine 

12. MAINTENANCE TABLE

Safety checks/check controls
Always check the electric devices are intact and working properly
Check the auger rotates freely
Apply silicone spray on the auger, to avoid ice formation
Check all the screw connections are tight. Tighten, if necessary.
Check the starter lever is only activated on 
release of the disengaged starter lever
General cleaning and inspection
Intervention
spare parts and accessories have been
designed specifically for machines.
• Non-genuine spare parts and accessories are
not approved. Use of non-genuine spare parts
and accessories cause the warranty to expire.
• It is advisable to send your machine 
once a year to an authorized service 
workshop for servicing, assistance 
and safety device inspection.

11. WARRANTY COVERAGE

The warranty covers all material and 
manufacturing defects. The user must 
follow all the instructions provided in 
the accompanying documentation.
The warranty does not cover 
damages caused by:
• Failure to become familiar with the 
documentation accompanying the machine.
• Carelessness.
• Incorrect or prohibited use or assembly.
• Use of non-genuine spare parts.
• Use of accessories not supplied or
approved by the manufacturer.
The warranty does not cover:
• Normal wear and tear of consumables, 
such as drive belts, drills, headlights,
wheels, bolts and wires.
• Normal wear and tear.
• Motors. Motors are covered by the 
warranty provided by the relative 
manufacturer in compliance with the 
specified terms and conditions.
The purchaser is protected by his own national 
legislation. The purchaser's rights envisaged 
by the national laws in his own country are 
not in any way restricted by this warranty.
Before and after each use
At the end of each operation
EN - 11
Frequency
Before each use
Before each use
Before each use
Before each use
Before each use
Paragraph
6.2
6.2
6.2.1
6.3
4
5.3
8.2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

St 8051 aeSt 515 liSt 615 li

Tabla de contenido