Technical Data - YATO YT-0763 Manual De Instrucciones

TECHNICAL DATA

Torque (min. - max.):
Defi nition of indications:
Precision of indications:
Angular range:
Precision of angle indication:
Angular speed:
Dimensions of the driver:
Working temperature:
Storage temperature:
Working relative humidity:
Power supply:
DESCRIPTION OF THE CONTROL PANEL
1. power supply switch
2. memory bank selection button / selection button
3. save button for the adjusted torque values or angle / change button for the direction of angle indication
4. reset button for the torque and angle values
5. display backlight / next digit / angle indication mode button
DESCRIPTION OF DISPLAY INDICATIONS
6. present torque value
7. angle indication unit
8. torque indication unit
9. programmed torque value
10. programmed angle value indicator
11. memory bank number
12. battery charge indicator
13. operating mode indicator
14. symbol of minus – for the purpose of indication of the torque for counter-clockwise movement
OPERATION OF THE WRENCH
Installation of batteries – turn the cap at the end of the handle counter-clockwise. Insert four alkaline AAA (1,5 V) batteries, with the positive pole into the
handle. Replace the cap. The wrench is ready to be used.
Turning the wrench on and off – press the power supply button; a short sound will be emitted by the buzzer, and for a couple of seconds all the symbols will
be displayed. In order to turn the wrench of, press the power supply button again.
Adjustments of the wrench – turn the wrench on, press button (3), and select the mode with button (2). The wrench may work in the peak value recording
mode (P) or in the value tracking mode (T), which is the default mode setting. Press button (3) again, and the wrench will automatically select the torque unit.
Using button (2) select the required torque unit. Press button (3), and the wrench will select the automatic turn-off time. Using button (2) select the period after
which the wrench will automatically turn off „5" minutes, „15" minutes, „Off" - the wrench will not turn off automatically. If button (3) is pressed, the wrench will go
into the operating mode. Attention! If during adjustments no button is pressed for more than three seconds, the wrench will automatically save the last setting
and will go into the operating mode.
O
20 - 200 Nm
15 - 148 Ft-lb
2 - 20 Kg-m
177 - 1770 In-Lb
0.1 Nm
0.1 Ft-lb
0.1 Kg-m
1 In-Lb
± 2%
5 - 360
O O
± 1%
10 / s - 360 / sek.
O O
1/2" (12,5 mm)
5 C - 40 C
O O
0 C - 50 C
O O
up to 90%
4 x AAA batteries (4 x 1.5 V)
P E R A T
GB
I N G M A N U A L
5