JOCCA 6644 Manual De Instrucciones página 10

18-E
-If your appliance has been dropped or fallen into water or any
other liquid do not use it or try to repair it. Take it to the JOCCA
technical service.
-For your safety and for the appliance to work correctly, always
use JOCCA spare parts and accessories.
-This appliance will only completely disconnect when the batte-
ries are taken out of the compartment.
-Please remove the batteries from the compartment if you are
not going to use the appliance for a long period of time.
-Four small type AA batteries should be used for the appliance to
work.
-Please change the batteries when they are exhausted. Only bat-
teries of the same model can be used, or equivalent to those
recommended.
-The batteries should be put in place in keeping with the correct
polarity indicated.
-Never put the battery compartment close to the fire or to a sour-
ce of heat.
-Please do not throw the batteries on the fire nor leave the con-
trol unit in the sun.
-When using this machine, please pay careful attention to the
needle and the knurled wheel. Never push the spool or the nee-
dle.
-The needle is sharp. Please be careful when working with nee-
dles in order to avoid harm.
-When not in use, the machine should always be kept in the bloc-
ked position.
INSTRUCTIONS FOR USE
-Before using the sewing machine, insert 4 AA batteries in the
compartment located at the back of the machine paying attention
to the polarity indicated inside (see drawing 0).
-Make sure that the sewing machine is locked before replacing
the batteries.
Locked - Unlocked
Start sewing:
-Turning the wheel, pull the arm of the needle to the highest posi-
tion. Note: The wheel can rotate in both directions. Hold the secu-
rity lever making sure that you are not pushing down the arm of
the needle (the arm can be moved manually even when the
machine is locked).
-Place the cloth under the security lever (see drawing 2).
-Introduce at least 5 centimeters of thread in the needle, from the
back to the front before starting to sew.
-Hold the sewing machine with your right hand and use your
thumb finger to press the ON button; hold the bottom part with the
other fingers (see drawing 3).
-Unlock the machine (see drawing 0). Press the button with your
right thumb finger. The machine will trail the cloth to the left auto-
matically with the adequate tension; use your left hand to hold the
cloth and control the direction (do not try to run the machine).
-If longer stitches are needed, move the cloth to the right a little
faster and sew at the same time. Follow the central line of the
security plate to obtain a straight final work (see drawing 4).
To finish the sewing:
-When you finish sewing, pull the arm of the needle to the hig-
hest position rotating the wheel. Then use a pair of scissors to cut
the thread after pulling it 8 cm approximately (see drawing 5 and
6).
-Use 8 cm of the final part of the thread to tie the knot according
to what is indicated in the images (see drawing12).
-First pass the needle threader through the last stitch.
-Place the thread in the needle threader.
-Pull 2 cm approximately.
-Direct the thread through the loop and pull it to tie the knot.
Press
Pull
Fig 0
E-19