Device Maintenance; Battery Replacement; Technical Specifications; Ce Declaration Of Conformity - Nice MhouseKit FL100W Instrucciones Y Advertencias Para La Instalación Y El Uso

6 - Troubleshooting...
The device does not respond as envisaged during a manoeuvre
This may occur for two reasons.
a) Insufficient power supply. Check the battery charge status with refer-
ence to the control unit manual. If the batteries are discharged due to a
more intensive occasional use than that admitted, wait for the photovoltaic
cell to recharge, or charge by means of a suitable battery charger. If the
problem occurs frequently, the cause may be a failure to observe the
warnings stated in the chapter "Technical Specifications", or the batteries
may need replacing (paragraph 7.1).
b) Disturbance in radio transmission-reception. Significant radio interfer-
ence may have occurred preventing communication with the automation
in the series Power&Free System System (occasional interference is sup-
ported well by the system). In this case, if the problem persists the "Op-
eration test" is recommended, as described in the Power&Free System
System manual, to analyse the level of device radio reception.

7 - Device Maintenance

This device does not require special maintenance provisions. To main-
tain efficient battery charging, the surface of the photovoltaic cell should
be kept clean at all times. To clean, use a soft damp cloth. Do not use
detergents containing alcohol, benzene, abrasives or similar. These could
obscure the reflective surface of the cell and reduce charging efficiency.
7.1 – Battery Replacement
The device batteries are rechargeable and tend to use some of their ca-
pacity after 4-5 years of operation, causing frequent low battery charge
signals. In this case they must be replaced. To access the battery com-
partment, refer to fig. 7; when replacing batteries, observe the following
warnings: • insert the new batteries taking care to observe polarity; • on
insertion of the batteries, check the Led flashes and relative meaning in
the automation control unit manual.
Disposal
Caution! – The product packaging material must be disposed of in full
observance of current local legislation governing waste disposal.
Caution! – This product is an integral part of the automation and
therefore must be disposed together with the latter.
As in installation, also at the end of product lifetime, the disassembly and
scrapping operations must be performed by qualified personnel.
This product is made of various materials; some may be recycled and
others must be disposed of. Seek information on the recycling and dis-
posal procedures envisaged by local regulations in the area for this prod-
uct category.
Caution! – some parts of the product may contain pollutant or hazardous
substances which, if disposed of into the environment, may cause serious
damage to the environment or physical health.
As indicated by the symbol alongside, disposal of this product
in domestic waste is strictly prohibited. Separate the waste
into categories for disposal, according to the methods envis-
aged by current legislation in your area, or return the product
to the retailer when purchasing a new version.
Caution! – the product is powered by batteries which may contain pollut-
ant substances, and therefore these must never be disposed of in public
waste. After removing them from the product (fig. 7) dispose of according
to the local regulations for battery disposal.
Caution! – Local legislation may envisage serious fines in the event of
abusive disposal of this product.

Technical specifications

• In order to improve products, the manufacturer reserves the right to
modify technical specifications at any time without notice, while maintain-
ing the original functionality and intended use. • All technical specifications
refer to an ambient temperature of 20°C.
n Power supply: by means of solar power transformed by a photovoltaic
cell and stored in 2 rechargeable batteries (1.2 V, type AAA NiMH). n So-
lar cell recharging autonomy: up to 15 cycles/day (1 cycle = opening
and closing), with maximum cycle duration of 60 seconds. n Charge
duration (without sunlight): estimated at 12 days, with 15 cycles/
day. n Radio communication: bidirectional, on 7 channels in the band
868MHz. n Radio protocol: high security; compatible with Mhouse's
Power&Free System System radio technology. n Useful radio range:
20m(**). n Maximum radio range (under optimal conditions): 40m.
n Radio communication safety: class 3 according to the standard EN
13849. n Light source: White led 1W. n Led lifetime: 80,000 hours. n
Protection rating: IP 44. n Operating temperature: -20°C ÷ +55°C. n
Dimensions: 145 x 135 x 125 mm. n Weight: 440 g.
Notes - Important warnings:
(*) - The estimated average number of manoeuvre cycles per day is based
on the device installed and used in the following conditions: • Photovoltaic
cell positioned in the correct direction; • device installation on a medium
latitude (for example that of Switzerland); • daily cell exposure to direct
sunlight of 100% potential; • device used in Winter; • clean photovoltaic
cell surface. Variations in these conditions will influence the average num-
ber of daily manoeuvre cycles.
(**) - The range of receiving-transmitting devices can be influenced by
other devices operating in the vicinity at the same frequency (for example
radio headphones, alarm systems etc.) which cause interference with the
system. In the case of continuous and strong interference, the manufac-
turer cannot guarantee the effective range of the specific radio devices.

CE Declaration of Conformity

Declaration in accordance with Directive 1999/5/EC
Note – The contents of this declaration correspond to declarations in the official
document deposited at the registered offices of NICE s.p.a. and in particular to the
last revision available before printing this manual. The text herein has been re-edited
for editorial purposes. A copy of the original declaration can be requested from NICE
s.p.a. (TV) I.
Number of declaration: 385/FL100W – Revision: 1 – Language: EN
The undersigned, Mauro Sordini, in the role of Chief Executive Officer, declares un-
der his sole responsibility, that the product:
Manufacturer's name: NICE s.p.a.
Address: Via Pezza Alta n°13, 31046 Rustignè di Oderzo (TV) Italy
Type: Mhouse wireless flashing light
Model: FL100W
Accessories:
Conforms to the essential requirements stated in article 3 of the following EC direc-
tive, for the intended use of products:
Directive 1999/5/EC OF THE EUROPEAN PARLIAMENT AND COUNCIL of 9 March
1999 regarding radio equipment and telecommunications terminal equipment and
the mutual recognition of their conformity according to the following harmonised
standards:
• Health protection (art. 3(1)(a)): EN 62479:20102
• Electrical safety (art. 3(1)(a)): EN 60950-1:2006 + A11:2009+A12:2011
• Electromagnetic compatibility (art. 3(1)(b)): EN 301 489-1 V1.9.2:2011,
EN 301 489-3 V1.6.1:2013
• Radio spectrum (art. 3(2)): EN 300 220-2 V2.4.1:2010
In accordance with the directive 1999/5/EC (appendix V), the product FL100W is
class 1 and marked:
Oderzo, 22/04/2014
Ing. Mauro Sordini
(Chief Executive Officer)
English – 2