Operation; Switching The Device Off - Wolf Garten LYCOS 40/300 T Instrucciones De Funcionamiento Originales

Operation

Operation
Inserting the power pack
Incorrect handling of the power pack and
the charger.
Risk of injuries and property damage.
Read and observe the operating instruc-
tions of the power pack and the charger.
The 2-stage latching mechanism is used to set ope-
rating or transport mode of the power pack.
Push the power pack into the power pack com-
partment until it engages in the desired position
/ .
Position 1
The power pack is in transport mode.
• The electric contacts are open to prevent the
power pack from self-discharging during stor-
age.
Position 2
The power pack is in operating mode.
• The electrical contacts are closed and the de-
vice is ready for use.
Switching the device on
Risk of injuries or material damage.
Always hold on to the device with both
hands during operation. One hand en-
closes the handle, the other hand holds
the middle handle.
Put on the carrying belt.
Press the lock-on switch on the handle
handle .
Release the lock-on switch again
The device operates.
Press the eco button
The speed of the cutting attachment reduces. The
lamp on the eco button goes green.
Note
section).
WARNING!
WARNING!
.
.

Switching the device off

.
Note
The cutting tool continues to run for a brief
Holding the device
Before you use the device, located in the
Operating position.
Check the following:
• The user is wearing the prescribed protective
equipment.
• The carrying belt is set to the correct length.
• The middle handle is adjusted correctly for the
body height.
- The middle handle is correctly adjusted, if you
can hold it with the hand, without having to
stretch your arm.
• The device is below waist height.
• The cutting attachment is held parallel to the
ground, so that the plants to be cut can be
easily accessed without the user having to bend
forward.
Line readjustment when operating with the
line head
The line head has a press knob with which you can
release the trimming line without having to stop
the motor. To release more trimming line, press
the press knob of the line head gently against the
ground while the device is running.
Note
maximum length. Line release becomes
.
trimming line becomes. Each time the press
Note
-Entanglement with foreign material
-Normal material fatigue
-Normal cutting process
EN
29