Transport And Storage - Wolf Garten LYCOS 40/300 T Instrucciones De Funcionamiento Originales

Transport and storage

- Remove any dirt and deposits on the spool
housing, spool and spool cap. Clean the individ-
ual parts with a clean
cloth.
- Replace the spool
- Align the retaining lugs of the spool cap with the
openings in the spool housing. Simultaneously
strongly press both of the engaging lugs of the
spool cap together
housing until it engages
Fitting and replacement of the trimming
line
Risk of injuries due to the cutting tool.
Only adjust the device with the motor
standstill.
Do not reach into the area of the rotating
line.
Always remove the power pack prior to
working on the device.
Never use metal-reinforced cord, wire,
chain, rope or similar. This could break
severely damage the device.
Use only original replacement line with
a diameter of 2.4 mm. Use of a thicker
trimming line can cause the motor to
overheat or fail.
Note
Cut the new trimming line to a length of 4 m.
Turn the press knob clockwise until the arrows on
the press knob and the spool cap coincide
Push one end of the trimming line into the inlet
line eye (LINE IN)
ming line through until it extends about 10 cm out
of the opposing line eye.
Pull the projecting end out so far that about 2 m
trimming line extends out of each line eye
knob clockwise until about 12 cm projects from
each line eye .
Note
.
and push it on to the spool
.
WARNING!
. Continue pushing the trim-
Risk of injuries due to the cutting tool.
the device and wait until the cutting tool
comes to a standstill.
Remove the power pack before transport
or storage.
Fit the safety cover onto the cutting
blade after every use and during trans-
port and storage.
Storage
Thoroughly clean your device after every season.
Always store the device in a dry and safe location
that is inaccessible to children.
Store the power pack and tool separately.
Store the power pack in a cool and dry loca-
tion. Recommended storage temperature ap-
prox. 0 - 23°C Keep the device and especially its
mineral oil containing products, penetrating oils
etc. They contain chemical substances that can
damage, attack or destroy the plastic components
of the device.
Fertilizers and other garden chemicals contain
substances that may have a highly corrosive ef-
fect on the metal parts of the device. Therefore do
not store the device near to these substances.
Store and safely lock away the cutting blade to
prevent damage to the blade and unauthorised
use.
-
.
.
-
Transport and storage
WARNING!
EN
31