Troubleshooting; Warranty; Ce Declaration Of Conformity; Environmentally-Friendly Disposal - Wolf Garten LYCOS 40/300 T Instrucciones De Funcionamiento Originales

EN
Risk of injuries or material damage
In case of doubt always consult a specialist workshop.
pack.
Problem Possible cause
The device The power pack is too hot.
The power pack is discharged. Charge the power pack.
The temperature of the device
(electronics) is too high.
Overcurrent release
The device will not The power pack is discharged. Charge the power pack.
switch on.
Overvoltage release
Overcurrent release
Power pack temperature too
high or too low.
The power pack is defective.
Readjustment of the The spool is empty.
line during oper-
The toothing between the spool
ation does not work.
housing and the line spool is
dirty.
been pulled into the line spool.
The line has become caught in
the spool.
The line is welded onto the
spool.
Strong vibrations Device fastening elements
have become loose.

Warranty

The warranty conditions of our local company or
importer apply in all countries. Under the terms of
the warranty we will repair faults on your device
free of charge, insofar as material or manufactu-
ring defects are the cause. To make a claim under
warranty please contact your seller or your nearest
branch.

CE Declaration of Conformity

instruction manual.
32

Troubleshooting

WARNING!
Remedy
Allow the power pack to cool.
Allow the device to cool and if necessary, clean the venti-
lation slots.
If this occurs again take your device to a specialist work-
shop.
If this occurs again take your device to a specialist work-
shop.
If this occurs again take your device to a specialist work-
shop.
Allow the power pack to cool down or heat up.
Replace the power pack.
Wind on a new cutting line.
Use a brush to remove dirt from the parts.
Remove the line spool and remove the line from the spool.
rewind the cutting line on it.
Remove the line and rewind the line.
Consult a specialist workshop.

Environmentally-friendly disposal

Electrical tools, accessories and packaging must be
routed into an environmentally compatible recycling
chain.
-
-
Power tools (without power packs/batteries):
Do not throw your old power tool away with the
domestic waste. Take it to a disposal facility.
Power packs/batteries:
Do not dispose of power packs/batteries
in domestic waste, by burning or throwing
into water. Power packs/batteries must be
collected, recycled or disposed of in an
environmentally-friendly manner.
Troubleshooting