Sears Kenmore PRO 790.79623 Manual Del Usuario página 11

Setting Surface Burner Controls
Setting the Dual ring Burner
The Dual Ring Burner has two rings of flame that you can control for two
different heat levels, one for small and one for large cookware.
Large Cookware Operation (Figure 1; Zone A & B)
1. Place a large cooking utensil centered over the dual surface Burner
Grate.
2. Push the surface control knob down and turn counterclockwise out
of the OFF position.
3. Release the knob and rotate to the LITE position (Figure 2). Note: All
electronic surface ignitors will spark at the same time. However, only
the selected surface Burner will lite.
4. visually check that the burner has lit.
5. When the burner is lit, continue to turn the control knob
counterclockwise between the HI position and the MED position
to adjust to the desired flame size for both burners together (Figure
1). DO nOT cook with any of the surface control knobs in the LITE
position (The electronic ignitor will continue to spark if the knob is
left in the LITE position).
Simmering Operation (Figure 1; Zone A)
1. Place a small cooking utensil centered over the dual surface Burner
Grate.
2. Push the surface control knob in and turn counterclockwise out of
the OFF position (See Figures 2).
3. Release the knob and rotate to the LITE position. Note: All electronic
surface ignitors will spark at the same time. However, only the Dual
Burner will ignite.
4. visually check that zone A & B of dual burner has lit.
5. Continue to turn the gas control knob counterclockwise past the
MED position; zone B will turn off. Adjust the simmer flame size
by turning the control knob between the MED position to the LO
position. DO nOT cook with the surface control knob in the LITE
position (The electronic ignitor will continue to spark if the knob is
left in the LITE position).
Off
11
Fig. 1
Lite Hi Med
Fig. 2
Fig. 3
B
A
Lo