Before Setting Surface Controls - Sears Kenmore PRO 790.79623 Manual Del Usuario

Before Setting Surface Controls

Locations of the gas Surface Burners
The STAnDArD sized burners are used for most surface
cooking needs. These burners are located at the center
rear and right rear positions on the cooktop. They can
also be used as SIMMEr burners with the simmer plate
to simmering delicate aliments as chocolate, sauces, etc.
The POWEr burners are best used for bringing large
quantities of liquid rapidly up to temperature or when
preparing larger quantities of food. These burners are
located at the right front and center front (when both
portions of the burner are in use) positions on the
cooktop.
The BrIDgE burner is best suited when using
rectangular or long shaped cookware. The left rear and
left middle are combined and controlled by the same
control knob. The left front burner may also be added for a
total of 3 burners.
Regardless of size, always select cookware that is
suitable for the amount and type of food being prepared.
Select a burner and flame size appropriate to the pan.
Never allow flames to extend beyond the outer edge of
the pan.
Check Burner Cap Placement Before
Operating the Surface Burners
To prevent flare-ups and avoid creation of harmful by-products,
do not use the cooktop without all burner caps properly
installed to insure proper ignition and gas flame size.
It is very important to be sure that all surface burner caps
and burner grates are properly installed and in the correct
locations BEFOrE operating the cooktop burners.
remember:
• Always keep surface burner caps in place whenever using
a surface burner.
• When placing the burner caps, be sure that all burner caps
are seated firmly and rest level on top of burner heads.
• For proper flow of gas and ignition of burners DO nOT
allow spills, food, cleaning agents or any other material to
enter the gas orifice port opening.
Standard Burners
This range is equipped with sealed burners as shown (see
Figure 1). All pieces are at their place. Take note where they
are. remove all packaging material located under the
bridge burner head. Make sure the burner is properly
aligned and leveled.
nOTE: There are no burner adjustments necessary on this
cooktop.
Left Rear Left Rear Center Front
Burner
Cap
Burner
Head
7
Center Rear Right Rear
350
300 400
250 450
200 500
Warm &
Broil
Hold
F Clean
Figure 1
Right Front