Taking A Blood Pressure Measurement - Healthy Living Deluxe Thinline BSD-3007 Manual Del Usario

•
Wrap the cuff around the arm (refer to previous
page)
•
Sit upright in a chair with feet flat on the floor.
•
Press " " or " " button to select a particular
memory zone then press the "START/STOP"
button to start the measurement. The monitor
will automatically inflate to the level that is
right for you.
•
When taking repeat measurements, make sure to select the same
memory zone before pressing "START/STOP", so the measurement is
registered to the appropriate memory.
•
If the result of your Systolic or Diastolic rate of your reading
result is greater than (not equal to) your set personalized
level the DIGIT will flash. In addition the measurement that
is out of range, either Systolic or Diastolic, will flash. If both
are out of range both will flash.
If the result of your Systolic or Diastolic rate of your reading result is
equal or less than your set personalized level a SMILING symbol will
show out and flash on screen.
The appearance of this symbol,
ularity was detected during the measurement. Talking, moving, shak-
ing or an irregular pulse during the measurement can result in the
appearance of this icon. Usually this is not a cause for concern, how-
ever if the symbol appears offen, we recommend you seek medical
advice. The device does not replace a cardiac examination, but serves
to detect pulse irregularities at an early stage.
•
To stop a reading in process, press the "START/STOP" button.
•
Press and hold "Mode" button to check the pre-set
personalized level.
Taking a Blood Pressure
Measurement
, signifies that a certain pulse irreg-

Taking a Blood Pressure Measurement

19