Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 1 – INSTALL THE BATTERIES
1. Open the Battery Door Screw using a Phillips head screwdriver.
2. Insert the included CR-123 Batteries using the battery orientation
markings on the side of the light.
3. Re-install the Battery Door Screw until fully tightened.
STEP 2 – INSTALL THE TWM ONTO YOUR FIREARM
NOTICE: Your TWM comes with both cross rail inserts pre-installed
in cross rail slots 1 & 4. If the location of one or both of these is not
correct for your specific installation, please go to our website for full
instructions to set up the TWM onto your firearm.
If the location of the pre-installed inserts is correct for your firearm,
proceed to the next step.
1. Push inward on the Rail Clamp Tension Thumbscrew fully
spreading the moveable Rail Clamp.
2. Place the moveable portion of the Rail Clamp into the groove
of the Picatinny rail and align the Cross Rail Inserts with the
desired slots.
3. Rotate the TWM onto the Picatinny rail and then release the
pressure on the Rail Clamp Tension Thumbscrew making sure
that the TWM is gripping both sides of the rail and verify that the
Cross Rail Inserts are fully seated into the slots.
4. While holding the TWM tightly to the rail, tighten the Rail Clamp
Tension Thumbscrew by hand.
5. Use a quarter to fully tighten the Rail Clamp Tension Thumbscrew.
CAUTION: PERIODICALLY CHECK THE CROSS RAIL INSERT
SCREWS AND THE RAIL CLAMP TENSION THUMBSCREW FOR
TIGHTNESS.
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
QSG-TWM-352-20
Publicidad
