YATO YT-7292 Manual De Instrucciones página 15

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 62
Single – permits to delete a single, currently displayed fi le. In order to delete the fi le, mark the option Yes and press the
button. In case deletion is abandoned, mark the option No and press the
menu.
All – permits to delete all the fi les in the current catalogue. This action should be realised in the same manner as in the case of
deleting single fi les.
Format - permits to delete all the fi les and catalogues in the memory card. This action should be realised in the same manner as
in the case of deleting single fi les.
Work with the device
The camera is connected to the device by means of a fl exible cable. The shape of the cable may be adapted for the conditions of
work. Avoid sharp bending of the cable in order not no damage it. The bending radius should not be smaller than 5 cm.
Be particularly careful while working with the device. In case of inspection of walls or conduits, make sure there will be no contact
with live objects like cables or metal pipes.
In case of inspection of vehicles, make sure the engine is off and all the elements which are subject to inspection are not hot. Make
sure the camera of the videoscope is not in contact with any liquids or harmful vapours and gases.
If necessary, it is possible to use during work one of the three auxiliary terminals supplied along with the device. The auxiliary
terminals are installed on the body of the camera. (V)
Connecting and disconnecting of the cable with the camera
The camera with the cable may be disconnected from the device. In order to do so, undo the clamp nut in the direction indicated
by the arrow, until the camera is disconnected. (VI)
Before you connect the camera, make sure the gasket at the end of the cable of the camera is not worn out or damaged.
While connecting the camera, make sure the protrusion at the end of the cable fi ts the notch of the device. (VII)
Tighten the nut fi rmly towards the direction opposite to the arrow.
Maintenance of the device
Once the work has been concluded, clean the casing of the device, e.g. with an air jet (whose pressure must not exceed 0.3 MPa),
a brush or a clean cloth, without any chemicals or cleaning agents. Do not use any agents that might scratch the screen. Place
the rubber protection cap on the camera.
Problem
The display is on, but there is no picture.
Shortly after the device is turned on, the lighting of
the camera begins to fade, the picture in the screen
fl ickers, the picture disappears from the screen, the
device turns off automatically.
The device cannot be turned on.
O R I G I N A L
GB
Possible reason
The cable of the camera is incorrectly connected to
the device.
The protective cap is placed on the camera.
Battery running down
Battery down
I N S T R U C T I O N S
button, after which the device will return to the
Solution
Connect the cable of the camera in accordance with
the instructions.
Remove the protective cap.
Charge the battery.
Charge the battery.
15

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Yt-7293

Tabla de contenido