Installation Instructions; Step 1 - Unpack The Refrigerator; Step 2 - Door Reversing - Haier HRB15N3 Instrucciones De Instalación

INSTALLATION INSTRUCTIONS

STEP 1 - UNPACK THE
REFRIGERATOR
WARNING
Excessive Weight Hazard
Do not puncture refrigerant tubing.
Follow handling instructions carefully.
Flammable refrigerant used.
Failure to do so can result in death, explosion or fire.
IMPORTANT: Handle with care when moving to avoid either
damaging the refrigerant tubing or increasing the risk of a leak.
REMOVE THE PACKAGING
• Remove tape and glue residue from surfaces before
turning on the refrigerator. Rub a small amount of liquid
dish soap over the adhesive with your fingers. Wipe with
warm water and dry.
• Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see "Refrigerator Safety."
• Dispose of/recycle all packaging materials.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator
the refrigerator straight out when moving it. Do not wiggle
damage could occur.
CLEAN BEFORE USING
After you remove all of the packaging materials, clean the
inside of the refrigerator before using it. See the cleaning
instructions in "Refrigerator Care."
8
Important information to know about glass shelves and
covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebblesize pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.

STEP 2 - DOOR REVERSING

(OPTIONAL)
The door hinges are factory installed on the right-hand
side. If you want the doors to open from the opposite
direction, you can reverse the door swing.
IMPORTANT:
• Before you begin, unplug the refrigerator, or disconnect
power.
• Remove food and the bins from the refrigerator door.
• The door hinges are designed to be right-hand swing or
lefthand swing specific. Replace the right-hand hinges
with the lefthand hinges provided in the parts bag. After
removing, keep the right-hand hinges in case you would
need to reverse the door swing.
Parts Provided:
• Top Hinge
• Center Hinge
• Bottom Hinge
Tools Needed:
• Flat-blade Screwdriver
• Phillips-head Screwdriver
• 8 mm Socket Wrench
REMOVE AND REVERSE
REFRIGERATOR DOOR
1. Unplug refrigerator or disconnect power.
2. Pull down to remove the hinge screw covers from the
wiring cover.
NOTE: The wiring cover spans the width of the cabinet top.
READ AND SAVE THESE INSTRUCTIONS
A
B
Wiring Cover
A
Hinge Screw Covers
B
49-1000580 Rev. 0