Haier HRB15N3 Instrucciones De Instalación página 9

INSTALLATION INSTRUCTIONS
3. Using a Phillips screwdriver, remove the four screws
attaching the wiring cover to the top of the refrigerator
cabinet. Lift up on the wiring cover and allow it to rest on
the top of the cabinet.
A
4. Disconnect the wiring harnesses, by pinching each end
and gently pulling them apart. Set wiring cover aside.
A
A Wiring Harnesses
B Wiring Cover
5. With your thumbs in the opening next to the hinge,
press upward on the top plate to release and remove it
from the refrigerator door. Set the top plate aside.
A
6. Lift up to remove the hinge cover, and keep it for
possible future use.
A Hinge Cover
49-1000580 Rev. 0
A
Screws
B
A
Top Plate
A
READ AND SAVE THESE INSTRUCTIONS
7. Using an 8 mm socket wrench, remove the two screws
attaching the top hinge to the cabinet.
8. Slide the top hinge to disengage it from the third screw
on the cabinet, and then lift up to remove the hinge pin
from the door.
NOTE: Save the top hinge for possible future use.
9. Lift the refrigerator door off of the center hinge, and
gently lay the door on a covered surface.
10. Using a Phillips screwdriver, remove the plastic door
closure and the metal door stop from the bottom of the
door.
A
B
11. Remove the screw from the door closure, and replace
the screw into the hole from which it was removed.
12. Move the door stop to the opposite side. Insert screw
into the center hole and fasten.
A
Door Closure
B
Door Stop
A
B
A
Screw
B
Door Stop
9