Tabla de contenido
Publicidad
Caution
Operating Temperature: This product is designed for a maximum
ambient temperature of 40°C.
Caution
All Countries: Install this product in accordance with local and
National Electric Codes. ! 15
Installing the Switch On a Desktop
The switch can be installed in a standard 19-inch rack or as a standalone unit,
such as on a table or desktop. To install the switch in a rack, go to the section
"Installing the Switch in a Rack" on page 6. To install the switch as a
standalone unit, perform the following steps:
1.
Remove all components from the shipping package and store the
packaging material in a safe location.
2.
Locate a level, secure surface for the switch.
3.
If you purchased an expansion module for the switch, install the module by
following the instructions in the AT-A15/SX, AT-A15/LX, AT-A16,
AT-A17, AT-A18, and AT-A19 Quick Install Guide.
4.
If you purchased a redundant power supply (RPS) unit for the switch,
connect the RPS unit to the R.P.S. Input connector (Figure 3) on the rear
of the switch by following the directions included with the RPS system.
Caution
If you intend to use a redundant power supply (RPS) with the switch,
check to be sure that the cable with the RPS unit is compatible with the
RPS Input Port on the switch. The pin assignments for the connector
are provided in the section Table 5 on page 11.
Warning
The power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord.
4
!
14
!
10
Publicidad
Tabla de contenido
