Setting Up For Local Management; Warranty Registration - Allied Telesyn AT-9006SX/SC Guía De Instalación Rápida

Setting Up for Local Management

If you are installing the switch in a TCP/IP environment or if you intend to
manage the switch from a remote site, you must first assign an IP address to
the switch using the Omega management software, which comes pre-installed
on the switch. To connect a terminal to the switch and start an Omega
management session, perform the following steps:
1. Connect a terminal to the RS232 connector on the front panel of the switch.
Use an RS232, DB-9 straight-through cable.
2. Access your terminal emulation program, that is, VT100.
3. Set your terminal emulator to the following:
"
Baud rate: 9600
"
Data bits: 8
"
Parity: None
"
Stop bits: 1
"
Flow control: None
4. Press Return.
The switch displays the Omega main menu.
You are now ready to use the Omega management software to configure the
switch. For instructions, refer to the AT-S26 Software Management User's
Guide. This guide is available on the Allied Telesyn web site at
www.alliedtelesyn.com.

Warranty Registration

When you finish the installation, register your product by completing the
enclosed warranty card and sending it in, or by visiting our web site at
www.alliedtelesyn.com/forms/warranty.htm and completing the on-line
registration.
8