Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Installation Instructions continued . . .
D
PLACE THE INFRARED MODULE ASSEMBLY ON TOP OF SPRAYHEAD. ROTATE UNTIL INFRARED MODULE LOCKS IN WITH TIE BAR.
DROP TWO INFRARED MODULE WIRES DOWN TO VALVE ASSEMBLY.
NOTE!
Skip to step E for units without soap.
•
FOR UNITS WITH SOAP OPTION, SLIDE THE SPACER AND SOAP DISPENSER OVER THE 1-1/2" PIPE.
POSITION THE UPPER TIE BAR SLIGHTLY BELOW THE MODULE (SEE FIGURE 8 INSET ON PREVIOUS PAGE) OR SOAP DISPENSER
E
(SEE FIGURE 9) AND FASTEN SECURELY TO VENT PIPE WITH SET SCREWS PROVIDED. SECURE TOP COVER TO TIE BAR WITH TWO
CAP SCREWS PROVIDED.
F
FOR B UNIT:
INSTALL 1/2" NOMINAL COPPER TUBING SUPPLY LINES (PASS THEM THROUGH HOLES IN COVER DOWN
THROUGH SUPPORT COLUMN) AND CONNECT SUPPLY LINES TO STOPS USING SUITABLE FITTINGS.
Bradley Corporation • 215-1187 Rev. N; EN 06-915B
UNIT WITH "B" DRAIN AND I.R. MODULE
SHOWN, ALSO AVAILABLE WITH "H" DRAIN
SOAP
DISPENSER
TIE BAR
Figure 9
TDB3108, WF3208 Terreon
TOP COVER
SPACER
INFRARED
MODULE
ASSEMBLY
S50-344
SPRAYHEAD
S05-054
SUPPORT TUBE
(STD.) S57-005
(JUV.) S57-006
4/6/2007
®
54" Circular
15
Publicidad
