Horizon Global 25002 Instrucciones De Instalación página 5

2. Drill & enlarge holes – Raise the hitch into position and align it with forward attachment holes. Use marker to mark a drill point at driver side rearward
hole center of the hitch bracket. Make sure the hitch sits straight with location marked. Lower the hitch down and use hand drill to drill a 1/2'' hole for
the driver side rear attachment hole. Using the same hand drill enlarge the passenger side rear attachment hole to 1/2".
3. Install hitch - Feed the carriage bolts ① and spacers ② to attachment holes through access holes using the pull wires ⑤, see Figures 1 & 2. Leave pull wires
attached. Gently pull the fascia and raise the hitch into position and feed the pull wires through bracket holes. Remove pull wires and loosely install conical washers ③
and hex nuts ④ to the hitch.
©2021 Horizon Global™ Corp - Printed in Mexico Sheet 5 of 18 25002NP 08-17-21 Rev. A