ARIETE grati PROFESSIONAL 448 Manual De Instrucciones página 9

26. This appliance conforms to the 2006/95/EC and EMC 2004/108/EC directives.
27. Any changes to this product that have not been expressly authorised by the manufacturer may
lead to the user's guarantee being rendered null and void.
28. In the event that you decide to dispose of the appliance, we advise you to make it inoperative
by cutting off the power cord. We also recommend that any parts that could be dangerous be
rendered harmless, especially for children, who may play with the appliance or its parts.
29. Packaging must never be left within the reach of children since it is potentially dangerous.
DO NOT THROW AWAY THESE INSTRUCTIONS
DESCRIPTION OF THE APPLIANCE (Fig.1)
A Container
B Container lid
C Power base
D Cheese grater lock slot
E Roller shaft
F Rear container lock
G Lever
INSTRUCTIONS FOR USE
Designed to grate any type of hard cheese or cheese that is not too soft. GRATI' can also be used
for dry bread, almonds, walnuts etc...
IMPORTANT: Carefully wash all removable parts before using, as described in the section entitled
"CLEANING AND MAINTENANCE".
IMPORTANT: ALWAYS UNPLUG THE POWER CORD FROM THE ELECTRICITY MAINS BEFORE
FITTING OR REMOVING SINGLE ATTACHMENTS OR BEFORE CLEANING THE APPLIANCE.
IMPORTANT: Before proceeding with use, make sure that you have correctly fitted all parts, as
described here below.
IMPORTANT: Do not try to grate soft cheese, as this will only clog the roller!
- Cut the cheese into cubes, remove any rind and place the cubes inside the hopper assembly (I).
- Plug the appliance into the power mains and press the switch (O). The switch will then light up.
- To start the motor and begin grating, lower the lever (G) with the hand grip (H) and press it against
the cheese (Fig. 2).
IMPORTANT: For the appliance to work, all parts must be fitted correctly and if not, make sure that
container (A) has been inserted into the relevant compartment as described below (Fig. 10-11).
IMPORTANT: The on/off switch (O) will stay lit, even if the appliance is not operating, i.e., with
the lever (G) raised or the container (A) not inserted or inserted incorrectly.
- For operating at intervals, it is sufficient to lift the lever (G); the appliance will be ready to use until
the switch is pressed (O).
IMPORTANT: To avoid overheating the appliance, do not use it continuously for longer than 5
minutes, and then allow it to cool down before reusing it.
H Hand grip
I Hopper assembly
L Grater roller
M Roller cap
N Brush
O Lit on/off switch
- 7 -
EN