Tabla De Contenido - CHIEF MSP-DCCUST1 Instrucciones De Instalación

MSP-DCCUST1
10. Place wall bracket over anchors and align mounting holes
in display mount with holes in anchors. (See Figure 8)
11. Insert Grade 2 or better 1/4-20 x 1-3/4" Phillips pan head
screws (not included) through Grade 2 or better 1/4" washer
(not included), corresponding mounting hole on wall bracket
and into Snap-Toggle (not included) and tighten until flush
against mount. DO NOT overtighten! (See Figure 8)
12. Repeat Steps 10 and 11 for remaining 3 mounting holes.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Overtightening of
mounting hardware can damage the steel studs. DO NOT
overtighten mounting hardware!
Steel Stud
Drywall
x 4
x 4
11
(G)
Anchor Metal Channel
SIDE VIEW
Figure 8
Adjusting Projector Mount
Lower projector mount [attached to short throw projector arm
(A)] to lowest position. (See Figure 9)
1. Loosen two screws (one on each side of projector mount).
(See Figure 9)
2. Turn the button head cap screw on top of mount
counterclockwise to lower the mount. (See Figure 9)
3. Loosen four hex head bolts. (See Figure 9)
4. Loosen center nut. (See Figure 9)
8
2 x 1
x 1
4
1
Figure 9
Installing Short Throw Projector Arm to Bracket
1. Attach arm adjust plate (C) to wall plate ensuring that adjust
plate tabs fit into notches on wall plate. Insert and slightly
tighten one 1/4-20 x 1-1/4" button head cap screw (HE). (See
Figure 10)
(C)
1
Figure 10
Installation Instructions
x 4
3
x 2
(G)
(HE) x 1