Optional Accessories; Protecting The Environment - DeWalt DW753 Manual Del Usuario

2. Move the workpiece backwards and forwards
over the belt.
Grinding can be done at three different points on the
grinding or honing belt (e).
• Use the area (A) over the large belt pulley (ll)
or the area (B) over the backing plate (s) for
preliminary grinding.
• Use the unsupported area (C) for finishing, as it
will mould itslef to the shape of the workpiece.
MAINTENANCE
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the switch is in the OFF position. An
accidental start-up can cause injury.
On a weekly basis, remove grindings from the
housing and the covers.
Putting the Machine Out of Operation
If the machine is put out of use for a longer period of
time, remove the honing belt from the machine and
store it in a dry and safe place.
To remove the belt, refer to the instructions for
Changing the Grinding or Honing Belt.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
E
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. This product must
not be disposed of with normal
household waste.
Take a worn grinding or honing wheel to your dealer
or a local recycling station where it will be recycled
or disposed of properly
Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
Separate collection of used products and
packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate collection
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
D WALT provides a facility for the collection and
E
recycling of D WALT products once they have
E
reached the end of their working life. To take
advantage of this service please return your product
to any authorised repair agent who will collect them
on our behalf.
EN G LI SH
WALT, have
E
WALT product
E
31