Eco Link Wiring - Lutron Electronics Energi Savr Node Manual De Instrucciones

English Español
Energi Savr Node
Step 3: ECO Link wiring
ECO Link wiring may be considered to be mains voltage. (It
is not considered SELV.) Consult applicable national and local
codes for compliance.
Lutron recommends using two different colours for separate
ECO 1 and ECO 2 links. This will prevent wiring mistakes where
several bus wires are co-located. Use the following instructions
for wiring the ECO Link.
WARNING! Danger of Shock. May result in serious
injury or death. DO NOT WIRE WHEN LIVE! Switch off
power via circuit breaker before wiring or servicing the
Energi Savr NodeT with EcoSystemR unit.
Buttons and LEDs on the front of the unit are used for
troubleshooting. If wiring is exposed when accessing
buttons and LEDs, the unit must be accessed by a certified
electrician, following local codes.
1. Turn power off.
2. Wire the ECO Link from the EcoSystemR terminals to all ballasts.
3. Turn on the circuit breaker to power up the Energi Savr NodeT
with EcoSystemR unit. The POWER indicator on the Energi
Savr NodeT with EcoSystemR unit will display a green light
continuously when properly powered up. If the indicator does
not light, turn off power, then check the mains voltage wiring
and repeat this step.
4. The Energi Savr NodeT with EcoSystemR unit outputs
EcoSystemR compliant voltage levels (18 V- + / - 4,5 V-). Use
a voltage meter to confirm this voltage.
5. Turn power off.
Wire Cross- Maximum EcoSystemR-compliant
sectional Area bus wire length
4,0 mm 829 m
2
2,5 mm 2 518 m
1,5 mm 311 m
2
1,0 mm 207 m
2
International Energi Savr Node
English
Français Português
with EcoSystemR
TM
with EcoSystemR Installation Guide
TM
Italiano Deutsch
|
Installation Guide

ECO Link Wiring:

ECO Link 1
• 1,0 mm to 4,0 mm
2 2
ECO 1
• Strip length: 6,0 mm
ECO 1
• Torque: 0,5 N m
•
中文
ECO Link 2
ECO 2
ECO 2
Lutron 5
|
®