Input Group Wiring; Sample Applications - Lutron Electronics Energi Savr Node Manual De Instrucciones

Energi Savr Node
Step 4: Input group wiring
To connect a daylight sensor, occupancy sensor and/or infrared
receiver, refer to the instruction sheets provided with the
devices. Diagrams for the PELV input terminals are shown
below.
WARNING! Danger of Shock. May result in serious
injury or death. DO NOT WIRE WHEN LIVE! Switch off
power via circuit breaker before wiring or servicing the
Energi Savr NodeT with EcoSystemR unit.
Buttons and LEDs on the front of the unit are used for
troubleshooting. If wiring is exposed when accessing
buttons and LEDs, the unit must be accessed by a certified
electrician, following local codes.
* Note: Only one IR device may be connected per input. If the IR
signal from a daylight sensor is connected, a wall control may not
be connected to the same input, and vice-versa.
** Connect the gray wire instead of the blue wire on LOS Series
occupancy sensors that include -R in the model number.
Sample applications: preconfigured modes require no commissioning
Link 1 Link 2
Wired to
input
group 1
Daylight
Sensor
Daylight Occupancy
Sensor Sensor
Perimeter Interior
Preconfigured mode 1
Perimeter daylighting
* Four fixtures shown on link 1 and eight fixtures shown on link
2, however, up to 64 ballasts can be connected per link.
Default Behaviour for Input Connections
Connected to input group 1
Connected to input group 2
Connected to input group 3
Connected to input group 4
Lutron 6
|
®
with EcoSystemR
TM
Energi Savr
NodeT with
EcoSystemR
unit
Wired to
input
group 4
Wired to
input
group 2
Occupancy sensor Daylight sensor
Controls link 1 only Controls link 1 only
Controls link 2 only Controls link 2 only
Controls both links Controls both links with equal daylight setting
Controls both links Controls both links with equal daylight setting
|
Installation Guide
IR Transmitter
20 V – 20 V-
IR – IR Receiver*
Photo – Daylight Sensor
Occ – Occupancy Sensor
Com – Common
Group 1 shown
NOTE: There are
four input groups.
Each group is
wired in the same
way and is shown
above.
Link 1
Occupancy
Sensor
Occupancy
Sensor
Perimeter Interior
Preconfigured mode 2
Two zones with occupancy sensors
* Six fixtures shown on each link. However, up to 64 ballasts
can be connected per link.
International Energi Savr Node
Daylight Occupancy
Sensor* Sensor
Group 2 shown

Input Group Wiring:

• 0,5 mm
2
• Strip length: 6,0 mm
• Torque: 0,5 N
Input Group 1 Input Group 2
Input Group 3 Input Group 4
Energi Savr
Wired to
NodeT with
input
EcoSystemR
group 1
unit
Link 2
Wired to
input
group 2
with EcoSystemR Installation Guide
TM
Wired Pico
R
Controller
to 4,0 mm
2
m
•