Stanley FATMAX FMC660 Manual De Instrucciones página 7

Labels on tool
The following symbols are shown on the tool:
:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.

Do not expose the battery to water.

Do not store in locations where the temperature may

exceed 40 °C.
Charge only at ambient temperatures between 10 °C and

40 °C.
Charge only using the charger provided with the tool.

When disposing of batteries, follow the instructions given

in the section "Protecting the environment".
p
Do not attempt to charge damaged batteries.
Chargers
Use your Stanley Fat Max charger only to charge the bat-

tery in the tool with which it was supplied. Other batteries
could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.

Have defective cords replaced immediately.

Do not expose the charger to water.

Do not open the charger.

Do not probe the charger.

The charger is intended for indoor use only.
$
Read the instruction manual before use.
+
Electrical safety
Your charger is double insulated; therefore no
earth wire is required. Always check that the
#
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Stanley Fat Max Service
Centre in order to avoid a hazard.
(Original instructions)
Features
This tool includes some or all of the following features.
1. On/off switch
2. Lock-off button
3. Main handle
4. Secondary handle
5. Spindle lock button
6. Shoe
7. Saw blade
8. Saw blade guard
9. Saw dust outlet
10. Battery
11. Charger
Assembly
Warning! Before assembly, remove the battery from the tool
and make sure that the saw blade has stopped. Used saw
blades may be hot.
Removing and fi tting a saw blade (fi g. B)
Removing
Keep the spindle lock button (5) depressed and rotate the

blade until the spindle lock engages.
Loosen and remove the blade retaining screw (15) by

turning it clockwise using the Allen key (16) supplied.
Remove the outer washer (14).

Remove the saw blade (7).

Fitting
Place the saw blade onto the inner f ange (13), making

sure that the arrow on the blade points in the same direc-
tion as the arrow on the tool.
Fit the outer washer (14) on the spindle, with the raised

part pointing away from the saw blade.
Insert the blade retaining screw (15) into the hole.

Keep the spindle lock button (5) depressed.

Securely tighten the blade retaining screw by turning it

counterclockwise using the Allen key (16) supplied.
Fitting and removing the battery (fi g. C)
To f t the battery (10), line it up with the receptacle on the

tool. Slide the battery into the receptacle and push until
the battery snaps into place.
To remove the battery, push the release buttons (17) while

at the same time pulling the battery out of the receptacle.
Use
Warning! Let the tool work at its own pace. Do not overload.
This tool can be used in the right hand or the left hand.
ENGLISH
7