Silva ADC SUMMIT Manual De Instrucciones página 36

12.7 Temperature Mode -
TEMP
OFFSET
18.3
Temperature Calibration Display
[mode]
TEMP
OFFSET
wind chill
temperature 18.3
Calibration Setting Display
hold [reset] [reset]
Select the
setting by
forward scrolling
Select the setting by
forward scrolling
(fast scrolling)
Calibrating the Temperature
8 C
0.0
8.3
hold [reset]
8 C
the offset
value
0.0
8.3
current
temperature
hold [set] [set]
Select the
setting by
backward scrolling
Select the setting by
backward scrolling
(fast scrolling)
To Select Setting Display
!
Following the previous '
Chill Temperature Alarm
the Calibration Display.
!
In the Calibration Display, press and hold
the [reset] button for 2 seconds to select the
Calibration Setting Display.
The Setting Sequence
!
When the 'offset value' digits are flashing,
press the [set] or [reset] buttons scroll
through to select target offset value (hold
down the button to scroll the setting at a
faster pace).
!
When the above settings finished, press the
[mode] button once to exit the setting
sequence.
Note:
1) When the temperature has been calibrated,
the ADC will offset the current temperature
by the target offset
If the offset value is +2 and the current
temperature is 26 degrees C, the ADC will
display 28 degrees C (26+2).
2) The current wind chill temperature will be
updated as above accordingly.
Setting the Wind
' section to select
value. For example: