Silva ADC SUMMIT Manual De Instrucciones página 41

13.4 Barometer Mode -
hold
[mode]
BARO hPa
1001.3
Barometer Mode
hold
[mode]
(Alarm OFF)
BARO hPa
[set]
STORM OFF
1001.3
current
Alarm OFF
barometric
pressure
Storm Alarm Setting
Setting the Storm Alarm
Storm Alarm and Pressure
Calibration Setting Sequence
[mode]
Stormy Pressure
Alarm Calibration
hold
Pressure
[mode]
Calibration Display
(Alarm ON)
BARO hPa BARO
OFFSET
STORM ON
1001.3
Alarm ON
[mode]
Calibration Setting Display
Check the 'Calibrating
the Temperature' section
below for more detail
Select the Setting Display
!
Press and hold the [mode] button for about
2 second to select the setting display (the
ON
' ' or '
Setting Sequence
!
In the setting display, press the [mode]
button to move the setting following the
adjacent diagram.
!
When the '
the [set] button to select the Stormy Alarm
between ON and OFF.
!
hPa When the above settings finished, press and
hold the [mode] button for about 2 seconds
0.0
to exit the setting sequence.
1001.3
hold
[reset]
OFF
' will start flashing).
ON OFF
' or ' ' starts to flash, press