15.5
Data Log Mode -
PC SYNC
PC SYNC ...
[set]
START?
STOP?
if the send
Ready
Sending
completed
PC Synchronization
Infrared Port
Pointing this port towards
the ADC-IR connected
to a PC
PC Synchronization
Transfer Data from the ADC to PC
!
The ADC is equipped with a function to
transfer/backup the data from the ADC to
PC.
!
To be able to transfer data to a PC, the
accessory ADC-IR (optional extra) is
needed.
!
Following the previous 'Data Log Mode
S e t t i n g S e q u e n c e ' t o s e l e c t t h e P C
Synchronization Display.
PC SYNC
!
In the above PC Synchronization Display,
START?
press the [set] button once to activate the
synchronization. The data of the ADC will
send to the target PC.
Note:
!
Start the PC's communication software prior
to the transmission.
!
Check the PC's hardware and software
manual for the detail on how to transfer and
receive data via infrared device.
!
Make sure that the infrared port (of the ADC)
is pointing towards the target ADC IR
infrared port during the transmission.