Digital Display; Multitab Button - Zanussi ZDT431 Manual De Instrucciones

1) The indicator light is off while a washing programme operates.
Delay start button
Use the delay start button to delay the start of the washing
programme with an interval between 1 and 19 hours. Refer
to the chapter 'Setting and starting a washing pro-
gramme'.

Digital display

The display shows:
• Adjusted level of the water softener.
• Activation/deactivation of the rinse aid dispenser (only
with multitab function on).
• Number corresponding to the selected washing pro-
gramme.
• Remaining time to the end of the programme.
• End of a washing programme.
• Number of hours in delay start.
• Fault codes.
• Activation/deactivation of the audible signals.

Multitab button

Press this button to activate/deactivate the multitab func-
tion. Refer to the chapter 'Multitab function'.
Function buttons
Use the function buttons for these operations:
• To set the water softener. Refer to the chapter 'Setting
the water softener'.
• To deactivate/activate the audible signals. Refer to the
section 'Audible signals'.
• To deactivate/activate the rinse aid dispenser, when
multitab function is active. Refer to the chapter 'Mul-
titab function'.
Audible signals
You can hear an audible signal:
• At the end of the washing programme.
• During the setting of the level of the water softener.
• When the appliance has a malfunction.
The activation of the audible signals is set at the factory.
Do these steps to deactivate the audible signals:
1. Switch on the appliance.
All manuals and user guides at all-guides.com
Indicator lights
The indicator light comes on when the washing pro-
gramme is completed.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C until the
indicator lights of function buttons A, B and C start
to flash.
4. Release function buttons A and B.
5. Press the function button C.
– Indicator lights for function buttons A and B go
off.
– Indicator light for function button C flashes.
– The digital display shows the setting.
The audible signals are activated.
6. Press the function button C again.
– The digital display shows the new setting.
The audible signals are deactivated.
7. Switch off the appliance to save the operation.
Do these steps to activate the audible signals:
1. Do the above procedure until the digital display
shows necessary setting.
Setting mode
The appliance is in setting mode when: .
• The programme selection indicator light is on.
• The digital display shows two horizontal lines (- -).
The appliance must be in setting mode for these opera-
tions:
– To set a washing programme.
– To set the water softener level.
– To deactivate/activate the audible signals.
– To deactivate/activate the rinse aid dispenser.
If:
• The programme selection indicator light is on.
• The digital display shows the programme duration (in
minutes).
Audible signals deactivated
Audible signals activated
21