Multitab Function - Zanussi ZDT431 Manual De Instrucciones

1
3
Fill the detergent dispens-
er (A) with detergent.

Multitab function

The multitab function is for combi detergent tablets.
These tablets contain agents such as detergent, rinse aid
and dishwasher salt. Some types of tablets can contain
other agents.
Do a check if these tablets are applicable for the local water
hardness. Refer to the instructions from the manufacturer.
When you set the multitab function, it stays on until you
deactivate it.
The multitab function stops automatically the flow of rinse
aid and salt. The rinse aid indicator light and salt indicator
light are deactivated.
The programme duration can increase if you use the mul-
titab function.
Activate or deactivate the multitab function before
the start of a washing programme.
You cannot activate or deactivate the multitab function
when the programme operates. Cancel the washing pro-
gramme, then set the programme again.
To activate the multitab function:
28
All manuals and user guides at all-guides.com
2
4
If you use a washing pro-
gramme with prewash
phase, put more detergent
in the prewash detergent
compartment (B).
5
Different brands of detergent dissolve in different
times. Some detergent tablets do not have the best
cleaning results during short washing programmes. Use
long washing programmes when you use detergent tab-
lets to fully remove the detergent.
• Press the multitab button. The multitab indicator light
comes on.
To deactivate the multitab function:
• Press the multitab button. The multitab indicator light
goes off.
Do these steps if the drying results are not satis-
factory:
1. Fill the rinse aid dispenser with rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position 2.
• You can only activate or deactivate the rinse aid dis-
penser when the multitab function is activated.
To activate/deactivate the rinse aid dispenser:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C.
– The indicator lights for function buttons A, B, and
C start to flash.
6