How To Maintain; Filter; Dust Cup - Eureka 100-110 Manual De Instrucciones

How To Maintain

The instructions in this booklet serve as a guide to routine maintenance. To keep the cleaner operating at top efficiency empty
the dust cup and clean the filter after each use.
Empty Dust Cup
CAUTION: Turn off the switch.
1. Remove hand vac from the base unit.
4. Shake contents of dust cup into a
waste container.
5. Replace dry dust cup filter in dust
cup and reassemble following above
directions in reverse.
NOTE: Replace a dirty or torn filter.
6. Dust cup may be cleaned with warm
water and mild detergent. Wipe dry, do
not put dust cup in dishwasher.
6
2. Push in on dust cup latch
and pull dust cup from
handle section.
Cleaning and Replacing Dust Cup Filter, PN 62406
Pull filter off of filter frame.
Shake and brush the dust and dirt from filter. If desired, launder filter by
hand in warm water using a mild detergent.
NOTE: Air dry thoroughly before returning to use.
To put filter on filter frame, pull and stretch the elastic edge of filter up and
over the rim on the filter frame.

Filter

Frame
Rim
Elastic
Edge
NOTE: If filter is not properly installed, dirt and dust will go past the
filter and this can damage the cleaner motor.
Clean Brush Roll
The brush roll turns to sweep and comb the carpet nap. Keep the brush
roll free from hair and threads so it will continue cleaning.
3. Remove dust cup filter from dust
cup. Shake and brush the dust and
dirt from filter.
Dust
Cup
Latch
Correct Installation