Additional Tips - Black and Decker LST201 Manual De Instrucciones

34 • ENGLISH
or other part that is damaged should be properly
repaired or replaced by an authorized service center
unless otherwise indicated elsewhere in this manual.

ADDITIONAL TIPS:

f Be familiar with the controls and the proper use
of the appliance.
f Wear stout shoes or boots to protect your feet.
f Wear long trousers to protect your legs.
f Before using the appliance, check that your cutting
path is free from sticks, stones, wire and any other
obstacles.
f Only use the appliance in the upright position, with
the cutting line near the ground. Never switch the
appliance on in any other position.
f Move slowly when using the appliance. Be aware that
freshly cut grass is damp and slippery.
f Do not work on steep slopes. Work across the face of
slopes, not up and down.
f Never cross gravel paths or roads while the appliance
is running.
f Never touch the cutting line while the appliance is
running.
f Do not put the appliance down until the cutting line
has come to a complete standstill.
f Use only the appropriate type of cutting line. Never
use metal cutting line or fishing line.
f Be careful not to touch the line trimming blade.
f Take care to keep the mains cable away from the
cutting line. Always be aware of the position of the
cable.
f Keep hands and feet away from the cutting line at all
times, especially when switching on the motor.
f Before using the appliance and after any impact,
check for signs of wear or damage and repair as
necessary.
f Never operate the appliance with damaged guards or
without guards in place.
f Take care against injury from any device fitted for
trimming the filament line length. After extending
new cutter line always return the machine to its normal
operating position before switching on.
f Always ensure that the ventilation slots are kept clear
of debris.
SPECIFIC WARNINGS FOR EDGERS
f Keep all body parts away from the cutting lines.
Do not try to remove the material being cut
when the blades are moving. Make sure the switch
is off when there is jammed material. A moment
of inattention while the edger is in operation can cause
serious personal injury.
f Carry the edger by the handle with the blade or
line stopped. When transporting or storing the
trimmer, always protect the cutting deck with the
appropriate device.
f Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
f This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
f Use the line trimmer only in daylight or good artificial
light.
f Never operate the line trimmer with damaged guards
or without guards in place.
f Switch on the line trimmer only when the hands and
feet are away from the cutting head.
f Never fit metal cutting blades.
f Use only the manufacturer's recommended
replacement parts and accessories.
f Always disconnect the line trimmer from the mains
when leaving the line trimmer unattended.
f Disconnect the line trimmer from the mains before
carrying out maintenance or cleaning work.
f Inspect and maintain the line trimmer regularly.
Have the line trimmer repaired only by an authorized
repairer.
f Take care against injury from the blade(s) fitted for
trimming the cutting line length. After extending new
cutting line, always return the line trimmer to its
normal operating position before switching on.
f When not in use, store the line trimmer out of the
reach of children.
f Face the cutting head away from yourself, other
people and animals while the power is connected to
the line trimmer (especially during operation).
f Disconnect the power when changing spools or
clearing grass from under the guard.
f Disconnect the power from the line trimmer before
making any adjustments.
f Use both handles.
f Keep ventilation openings clear of debris. Keep
handles dry, clean and free of oil and grease.
f Never reach underneath the line trimmer (the cutting
line area) until it has completely stopped and the
power has been disconnected.