Exception Codes - Airzone AZXCSMASTER Manual De Instalación Y Usuario

Fig. 16
Important: Caution with disabling and enabling programs
If you have configured a time programming and afterwards you disable it, this time programming will neither be
considered when automatic mode is running nor on priorities.
It is important to bear in mind that if a time program is disabled and a new program is configured overlapping the
disabled one, the disabled one will be automatically deleted upon enabling it again.
For example: If a program is configured from Monday at : to : of the next day (Tuesday). After
configuring, you disable it. And lastly you configure another program for Tuesday starting at : to :. Once
these three things are done, if you go to Monday and we try to enable the time programming, it will be deleted
automatically due to overlapping.

6. EXCEPTION CODES


- Communication error. If there is a communication error between the SuperMaster and
some of the systems associated, an error message will be display on the main screen.
Press and hold on so that the SuperMaster displays the address of the system or systems
in which there are some communication problems.
If there are some communication problems in more than one system, use the arrows to
navigate between the addresses of the affected main system controllers. Press on the icon
to return to the previous menu.
Check the correct operation of these main system controllers and verify the wiring of the
domotic bus between the systems and the SuperMaster.
Once this incidence has been resolved and after a few seconds, the screen will return to its
original status.

- SuperMaster reset. In case of a reset of the SuperMaster due to a power failure, a delay
of 30 seconds occurs during the initialisation process so that the systems previously associated
have been reinitiated correctly.
38