Getting Started - Smanos SS2603 Manual Del Usuario

EN
Entry&Exit Delay Time Setting (Used when the Siren Works as
a Siren only Alarm System without a control panel)
60
seconds 30
60S 30S OFF
If you don't want to carry along the remote control, you can
set the entry and exit delay time. Entry&Exit delay allows you
time to leave home before the siren is armed, or to disarm the
siren before triggering an alarm.
Note: During the delay time, the status LED will flash once every 1 second.
Arm/Disarm Tone Setting
ON OFF
ON OFF
Note: When siren works as an alarm panel, you can also arm, disarm or
home arm the siren mutely by using paired remote control even the arm/
disarm tone is switched to ON.
Press the [Home ] button, the LED indicator on the remote
control blinks once, and then press [Arm
[Disarm ] button within 3 seconds. The siren will be armed,
home armed or disarmed without making any noise.
OFF
seconds (default)
60S 30S OFF 60S 30S OFF
(default)
ON OFF
], [Home arm ] or
Usage

Getting Started

1. Load the 9V battery.
2. Set the volume and duration of the siren.
3. Start to use by pressing the power button on.
Note: The battery is used to charge the 18650 battery in case it is out of
power/with low power after a long time storage. Use the 9V battery to
charge 18650 for 12 hours and then remove 9V battery before installation
When installed as part of a
smanos Alarm System, the
Siren must be paired to the
Control Panel only.
The Siren will sound and the
strobe lights will flash upon
alarm activation. Disarming
the System will stop the siren
sounding. If not disarmed the
Siren Status Indicator will flash
once every 2 seconds for one
hour (visual notification of an
alarm event).
Pairing to a Control Panel
1. Press the Learn Button on the
Solar Siren (0.5 seconds), the
siren goes into Learn Mode after
one beep is heard.
2. Press the Arm or SOS Button on
the Control Panel(or press Arm
on App if the panel does not
have a button).
3. The Siren is paired with Control
Panel successfully after a second
beep.
4. If two beeps are heard, it is
already linked.
To give up pairing the Control
Panel, press the Learn Button
(before step 2 is done) again to exit
Learn Mode after one beep.
EN