Salami
130 g
Sliced beef
250 g
(approximately 2
cm)
Carrot
100 g
Dried fruits
130 g
Ice cubes
100 g
NOTE: This specified procedure time and speed is a general information.
• The actual amounts may be different according to the amount of foods and their
suitability.
• Check the results again according to how small the food is.
• Start it with short PULSE (1 pulse: approximately 1 second)
Assemblage of the appliance
WARNING: Do not fill the reservoir at the maximum level as the cutting blade may block
the reservoir according to foods solidity and suitability.
Pay attention to the instructions for different foods in this "Worksheet" section.
1. Place the reservoir that is on the reservoir's lid.
2. Place the blade.
3. Place the prepared food to the reservoir.
4. Place the actuator's lid onto reservoir and place two little recess' into the hollows in
the reservoir then rotate the actuator's lid clockwise until it is placed completely.
5. Place the motor unit to the top corner of the actuator's lid.
6. Plug the main plug in according to technical data given.
Chopping
• For a normal speed, press down the motor unit and then release it again.
• For a high speed, also press down TURBO button.
• Start it with short PULSE (1 Pulse: approximately 1 seconds) Pulse's length and number
depends on foods amount and their suitability. Check the features specified in "Worksheet"
section.
• Check the result again. If the food isn't chopped properly:
- Unplug the main plug, take out motor unit and shake the reservoir carefully.
- If food sticks to the reservoir, rotate the actuator's lid anticlockwise and take out. Use
a spatula and push down the pieces.
- Plug the main plug in again and before start up bring the pieces together.
Cleaning
Clean the appliance before the first use.
• Before cleaning the appliance unplug the main plug.
• Motor unit, power cable and main plug should be kept away from water.
3 x 5 seconds TURBO
3 x 12 seconds TURBO
3 x 5 seconds normal
4 x 15 seconds TURBO
Pulse/TURBO
- 12 -