Introduction; Correct Operation - Yale HTP Serie Manual De Instrucciones

17
I
NTRODUCTION
Products of CMCO Industrial Products GmbH have been built in accordance with the state-of-
the-art and generally accepted engineering standards. Nonetheless, incorrect handling when
using the products may cause dangers to life and limb of the user or third parties and/or
damage to the hoist or other property.
The operating company is responsible for the proper and professional instruction of the
operating personnel. For this purpose, all operators must read these operating instructions
carefully prior to the initial operation.
These operating instructions are intended to acquaint the user with the product and enable
him to use it to the full extent of its intended capabilities. The operating instructions contain
important information on how to operate the product in a safe, correct and economic way.
Acting in accordance with these instructions helps to avoid dangers, reduce repair costs and
downtimes and to increase the reliability and lifetime of the product. The operating instructions
must always be available at the place where the product is operated. Apart from the operating
instructions and the accident prevention act valid for the respective country and area where
the product is used, the commonly accepted regulations for safe and professional work must
also be adhered to.
The personnel responsible for operation, maintenance or repair of the product must read,
understand and follow these operating instructions.
The indicated protective measures will only provide the necessary safety, if the product is
operated correctly and installed and/or maintained according to the instructions. The operating
company is committed to ensure safe and trouble-free operation of the product.
C O
ORRECT PERATION
The hoist is used for overhead horizontal moving of suspended loads up to the indicated max.
load capacity.
ATTENTION: The unit may be used only in situations in which the load carrying
capacity of the device and/or the supporting structure does not change with the load
position.
Any different or exceeding use is considered incorrect. Columbus McKinnon Industrial
Products GmbH will not accept any liability for damage resulting from such use. The risk is
borne by the user or operating company alone.
The load capacity indicated on the unit is the maximum working load limit (WLL) that may be
attached.
The selection and calculation of the appropriate supporting structure are the responsibility of
the operating company.
The attachment point and its supporting structure must be designed for the maximum loads to
be expected (deadweight of the unit + load capacity).
The hoist is suitable for a wide range of beams as well as for various profiles (e.g. INP, IPE,
IPB, etc.) with a max. inclination of the beam flange which does not exceed 14°.
The runway and its supporting structure must be designed for the maximum loads to be
expected (deadweight of the unit + load capacity). The runway must only have a deflection of
max. 1/500 of the span.
The longitudinal gradient of the travel path surface may not exceed 0.3%.
The air gap between the wheel flange and the beam flange ("dimension A") must range
between 1.0 and 2.5 mm on either side of the trolley (depends on model).
©
2015 Columbus McKinnon Industrial Products GmbH