Yale HTP Serie Manual De Instrucciones página 21

21
HTP/HTG 8 - 20 t
1. Measure the flange width of the beam.
2. Evenly distribute the spacer sleeves and spacer washers on both sides of the clevis load
bar in accordance with the flange width. The correct distance between the trolley wheel flange
and the beam flange must be maintained to either side (dimension "A", Tab. 1).
3. After adjustment of the inner dimension, evenly distribute the remaining spacer sleeves and
spacer washers on the outside of the side plates on the ends of the load bar. In each case, at
least 3 washers and 1 sleeve must be mounted between the side plates and the castle nuts.
Tip: For easier assembly, tighten one side plate, distribute the required combination of spacer
sleeves and spacer washers, the clevis and the remaining spacer sleeves and spacer washers
on the load bars and place the other side plate onto the load bars. Screw on castle nuts
without tightening.
4. If the beam intended for assembly has an accessible open end, assemble the trolley on the
ground and slide it onto the beam at the open end. If the intended supporting structure has no
open end, increase the distance between the side plates temporarily to the extent that the
wheels can be lifted over the beam flange and can be set down on it. If the distance of the
wheels cannot be opened wide enough, remove one of the side plates and refit it on the beam.
5. When the correct distance between the side plates has been set, tighten all castle nuts.
6. Secure all castle nuts with cotter pins.
ATTENTION: A trolley must never be used on a beam with a flange width that exceeds
the maximum adjustable width of the trolley (observe total clearance of 5 mm, depends
on model) or with a profile which does not correspond to the profile the trolley has
been designed for.
Shorten or extend the hand chain (model HTG only and all trolleys with locking device)
Adjust the length of the hand chain so that the distance of the lower end to the floor is between
500 – 1000 mm.
NOTE: For safety reasons, hand chain links may only be used once.
©
2015 Columbus McKinnon Industrial Products GmbH