Assembly - Yale HTP Serie Manual De Instrucciones

20
Do not allow the unit to fall from a large height. Always place it properly on the ground.
The unit must not be used in potentially explosive atmospheres (special models on request).
A
SSEMBLY
Inspection of the supporting structure
The supporting structure has to be selected to ensure that it has sufficient stability and the
expected forces can be safely absorbed.
Make sure that no impermissible additional loading may occur as a result of fitting the hoist
(e.g. by side pull).
The selection and calculation of the appropriate supporting structure are the responsibility of
the operating company.
HTP/HTG 0,5 - 5 t
1. Screw the end of the clevis load bar marked "L" (left-hand thread) approx. 3 mm into the
side plate also marked "L". The trolley wheels point in the direction of the clevis.
2. Screw the second side plate with the trolley wheels also pointing in the direction of the
clevis approx. 3 mm onto the other end of the clevis load bar.
3. Screw the clevis load bar further into the side plates until both ends protrude over the side
plates on the outer sides.
In addition for type B
4. Screw the limit stop screws with the spring washers and the cylinder screws onto the ends
of the clevis load bar in accordance with Fig. 8. They prevent unintentional turning of the clevis
load bar when the trolley is adjusted to the maximum trolley width and must always be fitted.
5. By rotating the clevis load bar further, the trolley width is roughly pre-adjusted to the
required beam size.
6. If the beam intended for assembly has an accessible open end, assemble the trolley on the
ground and slide it onto the beam at the open end. If the intended supporting structure has no
open end, increase the distance between the side plates by turning the clevis load bar to the
extent that the wheels can be lifted over the beam flange and can be set down on it. If the
distance of the wheels cannot be opened wide enough, remove one of the side plates and refit
it on the beam.
7. The distance of the wheel to the beam flange (dimension "A", Tab. 1) is then precisely
adjusted by turning the load bar.
8. After assembly of the trolley on the supporting structure, fit the end stops on the beam.
ATTENTION: With the max. permissible flange width for the trolley, both ends of the
clevis load bar must at least be flush with the side plates.
Only on type B up to 5000 kg
9. Adjustment of the anti-tilt device :
Loosen the cylinder screws and push the link plates in the direction of the lower side of the
beam, so that they have a distance of 3 to max. 5 mm to the beam over the entire travel path.
©
2015 Columbus McKinnon Industrial Products GmbH