Program Setting - REV Ritter EMP701MT Manual De Instrucciones

7. Program setting

1. Once the spike has been connected to the mains, turn the dial
clockwise until the arrow indicates the current time on the dial
2. Due to transport requirements, all pins on the timer are pressed
down upon delivery. Before programming make sure that all the
pins are in the top position.
3. Press down all pins within the period in which the spike should be
enabled. Each pin corresponds to a period of 30 minutes.
Example: To activate the earth spike from 10 pm to 2 am, press
down all the pins in the time range between
10 pm and 2 am. (See images below)
The current time is 9 pm.
24
GB
9