Installing The Switch On A Desktop - Allied Telesyn AT-8316F/MT Guía De Instalación Rápida

Installing the Switch On a Desktop

The Ethernet switch can be installed in a standard 19-inch rack or on a table
or desktop. To install the switch in a rack, go to the section "Installing the
Switch in a Rack" on page 8. To install the switch on a table or desktop,
perform the following steps:
1. Remove all components from the shipping package and store the
packaging material in a safe location.
2. Locate a level, secure surface for the switch.
3. If you purchased an expansion module for the switch, install the module by
following the instructions in either of the following manuals:
AT-8316F/MT, AT-8316F/VF, AT-8316F/SC, and AT-8324 Installation
Guide or AT-15/LX, AT-A15/SX, AT-A16, AT-A17, AT-A18, and AT-A19
Quick Install Guide.
4. For instructions on building a stack by interconnecting this switch with
other AT-8316F or AT-8324 switches, refer to either of the following guides
for instructions: AT-8316F/MT, AT-8316F/VF, AT-8316F/SC, and
AT-8324 Installation Guide or AT-Stack8 Stacking Matrix Module
Installation Guide.
5. For an AT-8316F or AT-8324 switch that will not be part of a stack, check
the setting of the Stack ID switch on the back panel of the switch (shown
in Figure 2). You can set the switch to any setting (1 to 8), but not 0 (zero).
Figure 2 Stack ID Switch
AT-8316F and AT-8324 Quick Install Guide
STACK ID
1
IS-A IS-B
STACK ID
0
5