Installing The Switch In A Rack - Allied Telesyn AT-8316F/MT Guía De Instalación Rápida

Installing the Switch

Installing the Switch in a Rack

To install the Ethernet switch in a standard 19-inch rack, perform the
following procedure:
1. Remove all components from the shipping package and store the
packaging material in a safe location.
2. Locate a level, secure surface for the switch.
3. If you purchased an expansion module for the switch, install the module by
performing the instructions in either of the following manuals:
AT-8316F/MT, AT-8316F/VF, AT-8316F/SC, and AT-8324 Installation
Guide or AT-15/LX, AT-A15/SX, AT-A16, AT-A17, AT-A18, and AT-A19
Quick Install Guide.
4. Remove the snap-on plastic feet from the bottom of the switch, as shown in
Figure 5.
5. Attach the mounting brackets to each side of the switch, using the six
flathead screws that came with the switch package as shown in Figure 6.
6. Mount the switch in the rack using standard screws (not provided).
8
Figure 5 Removing the Feet
M I R
R O R
P O R
T
L IN K
R S -
T E R
2 3 2
M I N
A L P
O R T
S T A T
U S
X
Figure 6 Attaching Rackmounting Brackets